OMSI 2 Cheat Codes - Trainers City - Cheats & Soluces -




Name of the file: OMSI 2 Cheat Codes - Author: DAV

Cheat Codes:
------------
Submitted by: David K.

Guidance for Ikarus:
--------------------
Written by comradekiller72

-=Get started=-
* Jump into the driving seat
* Switch on the batteries * press E, or tap the right arrow button til you see
the dashboard. Make the steering wheel disappear and click a black switch in
the middle and the dashboard is “alive” now.
* Press the red button near the key to start the engine. Depending on how you set
the maintenance level and weather conditions, you need to apply throttle by Num8
to make the Rába engine jump in. Quick tip: you can shorten it by pre-heating the
engine. In the passenger compartment open the first lid on the floor. There is a
valve for heating. Click on it. Go back to the driver’s seat. There is a panel
near the left leg of the driver. The upper one controls the pre-heater and the
circulating pump. Switch to the upper position to ignite the heater and have the
pump on. Wait until the coolant temperature reach 40 Celsius and start.
The engine jumps in immediatelly.
* Very tedious part, wait til the compressor fills up the pneumatic system. It takes
a couple minutes, because the two brake circuits, the auxilary circuit for the
doors, and the circuit for the air springs need to be filled. Wait til the big
red indicator is off or the bus lifted up from the “kneeling”.

-=Driving
The bus has a manual transmission, 6 speeds.
* Start from second gear, the first gear is needed at hill start only
* Shift up at 1800 rpm at flat ground, when you go uphill, 2100 rpm.
* Cruising speed is at 1500 rpm, so the Citybus series has 50km/h at that rpm,
the Regiobus has 60km/h.
* The motor brake works by the “K” key in default. It has a very distincive sound -
the hungarian slang for it is “bubu”.

-=How to shut the engine down:
* Switch to neutral, and press the “K” key. It shuts the engine down.
* When the air pressure is not sufficient enough, you have to stall the engine.
* Press the Tab key + any number key from 1 to 6, the release the Tab key.

-=Heating:
* Open the valve under the first lid on the floor
* Near the driver’s left leg there are two panels. The upper one controls the
“Thermal” heating. Flip the switch to the upper position for pre-heat the engine
and turn the circulating pump on. When the engine is warm - 80 degrees Celsius -
flip the switch down for the circulating pump only.
* The seond panel controls the dry-air heater. The closer switch to you controls
the heater, up position is heater, middle is off, down is ventilation.
The fartest one controls the intensity.



Copyright (c) 1998 - 2024 - Trainers City - The Trainers Bible - All Rights Reserved - back